IEC 61439 is the International Electrotechnical Commission standard which covers low voltage switchgear and controlgear assemblies. The standard gives details on the requirements of these products through testing and other verification methods.
It is a replacement for IEC60439 and is now the industry standard requirement for ALL low voltage switchgear and controlgear Panel Assemblies
IEC 61439 has been achieved by less than 1% of the Control Panel manufacturers in the UK
This standard is a significant change from the previous one, one of the most surprising changes for some will be the removal of the terms ‘type tested assembly’ and ‘partially type tested assembly’, these have been replaced by ‘design verification’
The twelve design verification characteristics are split down into two main areas, that of ‘construction’ and ‘performance’.
Strength of materials and parts
This looks at the suitability of plastics and metals to prove the long term capabilities of the equipment.
Degree of protection of enclosures
This references the same standard as before.
Incorporation of switching devices and components
This requires the panel builder to ensure that devices are installed in line with manufacturer’s instructions.
Terminals for external conductors
This, again, puts the onus on the panel builder to ensure that the contractor will be able to terminate his cables on to the switchboard.
One of the biggest areas of change in the standard revolves around this area. No longer can you fit a device into a compartment and rate it at a level it would not be capable of carrying without exceeding the limits set by the standard. The standard now requires that the maximum current a circuit is capable of carrying, within the temperature limitations, is noted as its rating, irrespective of what the device manufacturers claims for the device alone.
Short circuit withstand strength
This is principally the same set of tests as per the previous version of the standard, with a few amendments.
This ensures the components of the system are mounted in such a way that through normal use, they will not fail or change the capabilities of the switchboard. In this case the test value is set at 200 operations.
Quantum Controls Responsibilities
Upon completion of the above, and moving into production, the standard requires routine verification be carried out by the Control Panel Manufacturer to ensure continued compliance to the design verified solution is met. These routine verifications must be carried out on each and every MCC / Control Panel / Switchboard that is manufactured and is principally a simplified subset of the 12 design verification characteristics, but this cannot be seen just as a job for the final QC department, since important areas such a device ratings, terminal sizes, swapping of components etc. needs to be fully investigated prior to any work being started.
Quantum Controls have enhanced their current test and inspection stages of design and production to ensure that we fully comply with the new IEC 61439:2009 standard. We have fully designed and manufactured a fully functional Motor Control Centre with various ratings, type and manufacturers brands of components incorporated.
In partnership with of 3 Phase design we have accomplished the full verification and testing process, including performance areas such as Temperature Rise, Short Circuit withstand strength and Mechanical Operation, to ensure Quantum Control Ltd are fully certified to manufacture electrical control panels to the new 61439:2009 standard. An achievement less than 1% of UK Panels Builders have achieved
To send us your Control Panel Quotation Request simply click here
For all your other queries please get in touch. Email us email@example.com or phone us 0330 9000 247